Papers

Title 1
Secure M2M Communication of Industrial IoT using Manufacturing Message Specification (MMS) with Blockchain
Winter Intensive Paper (Elsevier Information Processing Letters)


Title 2
1D CNN-based Event Classification for M2M MMS over Blockchain (MoB) Communication
For Graduation Thesis

Last Week's Progress

Title 1
- Submitted to the Journal. (April 22 2020)


Title 2
- Write brief introduction of MMS section.
- Add three different configurations of CNN model in a table.
- Add model accuracy results of the three proposed configurations in training process.
- Continue in testing process and real-time testing from sensors.

This Week Todo's

Title 1
- Rejected because out of scope. (May 05 2020)
- Find another suitable letter.


Title 2
- Add comparison table of loss and accuracy on the three configurations between the previous architecture and the proposed system.
- Add comparison table of accuracy and processing time between the three configurations and Standard Scaler pre-processing in testing process.
- Add model loss/accuracy result of the third proposed configuration in training process using Standard Scalar pre-processing.
- Successfully classify sensor data in real-time.
- Finish the 1D CNN part by the end of this week.

Project Progress

MMS for Industrial IoT, E-WAMS: Edge Computing-based Wild Animal Monitoring System (Capstone Design Class), 3D Printing Conception Company, and International Conference Sectio

Last Week's Project

3D Printing
- Add write function to the schematic.
- Debugging time error when executing write function without highlights.

This Week's Project

3D Printing
- Debugging time error when executing write function without highlights.

Monthly Goals

- Finish the winter intensive and submit the chosen journal.
- Use 1D CNN for real-time event classification.
- Combine MMS over BC to increase data security.
- Successfully connect the sensor (Arduino) to LabView through serial communication.
- Use the OPCUA Labview library.
- Make a good UI consists of many sensors and the connection status of the 3D Printing.

Annual Goals

- Able to submit and take a part in at least one Domestic conference.
- Able to submit and take a part in at least one International Conference and Journal.