Papers

Title 9: Smart Monitoring for SLA-type 3D Printer using Temporal Convolutional Network
(Tentative Title, Winter Intensive 2020)

Title 7: UAV-Assisted Uplink Communication using Dragonfly Optimization Algorithm for URLLC in Military Operations
- Target Journal: IEEE Communication Letters

Title 1: Secure Ground Control Station-based Routing Protocol of UAV Network
- Accepted in ICTC 2019

Title 2: Monarch Butterfly Optimization on DV based Positioning in Indoor Industrial Environment
- Accepted in KICS Fall 2019

Title 5: Hardware-in-the-Loop 3D Printer Oxygen Agent Monitoring Program using LabView
- Journal Publication (3D Project Journal Paper)

Title 3: Efficient UAV Deployment Strategy for Energy-Efficient Routing Protocol using Monarch Butterfly Optimization Algorithm
- Target Journal: IET Communications Journal

Title 4: Enhancing Localization Accuracy in Indoor Industrial Environment using Metaheuristic Algorithm
- ICTC 2020

Title 6: Smart Monitoring for SLA-type 3D Printer using Artificial Neural Network
- KICS SUMMER 2020

Title 8: Hybrid Deep Neural Network for Malicious DNS Infiltration Detection System
- As the second author
- Submitted in WCNC

Last Week's Progress

Title 7: UAV-Assisted Uplink Communication using Dragonfly Optimization Algorithm for URLLC in Military Operations
- Explain the simulation results
- Add tables to present the results

Title 9: Smart Monitoring for SLA-type 3D Printer using Temporal Convolutional Networks
- Insert simulation results and abstract

This Week Todo's

Title 7: UAV-Assisted Uplink Communication using Dragonfly Optimization Algorithm for URLLC in Military Operations
- Improve the related works
- Revise the equations


Title 9: Smart Monitoring for SLA-type 3D Printer using Temporal Convolutional Network
- Start with introduction and related works
- Explain the simulation results

Project Progress

3D Monitoring Project

Last Week's Project

- Since the dataset has been gathered and the setup is currently working, I will proceed to place the circuit in an universal pcb board to achieve the set-up

This Week's Project

- Start plotting the circuit in universal pcb board and solder the sensors permanently
- Proceed with testing the circuit board into the 3D Printer

Monthly Goals

- Start the Winter intensive paper - 15%
- Finish Summer Intensive paper -85%
- Finish the 3D Project - 25%

Annual Goals

- Write two SCI journals
- Submit a paper on
(1) International - 100%
(1) Domestic conference paper - 100%
(1) SCI Journal - 85%
(1) SCI Journal - 15%
- Finish the 3D project - Back to 25%