Title 9: Smart Monitoring for SLA-type 3D Printer using Temporal Convolutional Network
(Tentative Title, Winter Intensive 2020)
Title 7: UAV-Assisted Uplink Communication using Dragonfly Optimization Algorithm for URLLC in Military Operations
- Target Journal: IEEE Communication Letters
Title 9: Smart Monitoring for SLA-type 3D Printer using Temporal Convolutional Network
- Finish the system model and define roughly the scope and delimitation of the paper.
- This is the extension of the KICS Winter 2020 and by that, I am still implementing my proposed model in real-time simulation using the LabVIEW program. However, I encountered a problem with the sensor that I'm using and until now, I am still waiting for the sensor to arrive.
Title 7: UAV-Assisted Uplink Communication using Dragonfly Optimization Algorithm for URLLC in Military Operations
- The simulation is a lot harder than we thought. We are still troubleshooting the simulation in Matlab, and in addition to the struggle that we are facing is that it takes a long time to simulate one cycle, and often times during the simulation period there's an unexpected error to happen when it's almost done.
Title 9: Smart Monitoring for SLA-type 3D Printer using Temporal Convolutional Network
- This week, I hope that the sensor that I requested would finally arrive so that I can start my implementation. For now, I am busy building a LabVIEW program that is capable of integrating a machine learning algorithm on it. This will be hard since there are limited sources on the internet about this but I will try to finish it within this week
Title 7: UAV-Assisted Uplink Communication using Dragonfly Optimization Algorithm for URLLC in Military Operations
- With the help of Sanjay, we hope to push through the completion of this paper on the 1st week of March. The system model and introduction are all set, the only thing that we are working at is the simulation and related works.
3D Monitoring
- Since there is a problem with one sensor, they have requested for a new one but they said that the request will be granted next month so we have to wait for it.
- I will wait for further announcements about this project but for now, we will focus on journal writing this week.
- Finish the LabView Program for the 3D Project
- Finish Winter Intensive paper
- Finish the UAV paper by the end of February or early March at least.
- Integrate an edge computing device on the Monitoring program for the future expansion of the project or the possible integration with 5G technologies.
- Finish my thesis and graduate.