Papers

Made Adi Paramartha Putra

- Title 6: Data Prediction-Based Energy-Efficient Architecture in Industrial Internet of Things - IEEE Sensors Journal(On Revision)

- Title 7: Efficient 3D Printer Fault Classification using Multi-Block 2D Convolutional Neural Network - KICS Journal (Accepted)

- Title 8: Composite Multi-Directional LSTM for Accurate Prediction of Energy Consumption - ICOIN (Accepted)

- Title 9: Fault Detection in 3D Printers using an Improved YOLOv5 with Hyperparameter Tuning - KICS Fall 2021 (Accepted)

- Title 10: FDP: A Fog Data Prediction Testbed Architecture to Enhance IoT Sensor Lifetime - ICC (Rejected)(On Revision)

- Title 11: FDPR: A Fog Data Prediction and Recovery Algorithm in IoT Networks- Winter Intensive - IEEE Transactions on Industrial Informatics (Submitted)

- Title 12: Towards Delay Aware Data Recovery using Deep Learning in Embedded IoT Application - KICS Winter 2022 (Accepted)

- Title 13: Adaptive Data Prediction Protocol for IoT Application - IEEE Journal

- Title 14: Design and Implementation of 3D Printer Monitoring System for Industries - ICT Express - 3D Printer Project

- Title 15: IDS Survey - with Gabriel and Mark

Last Week's Progress

Title 11: IEEE Transactions on Industrial Informatics
- Periodically check the submission

Title 7: IoT Journal
- Continue to revise the manuscript based on reviewer comments

Title 15: IDS Survey
- Start writing the paper
- Add more paper references

This Week Todo's

Title 11: IEEE Transactions on Industrial Informatics
- Continue to check Periodically

Title 7: IoT Journal
- Continue to revise the manuscript based on reviewer comments
- Prepare to change journal format

Title 15: IDS Survey
- Continue to write the paper
- Add more paper references

Project Progress

3D Printer Monitoring

Last Week's Project

- Working on the sensor control module for the next project goals

This Week's Project

- Add a control section for the data gathering process.

Monthly Goals

- Finish revising previous Summer Intensive paper and prepare for submission ()
- Finish 3D Printer Monitoring Project [Task-2] ()

Annual Goals

* Accepted in 2 Local and International Conference: (✓)
- ICOIN 2022 (✓)
- KICS Winter 2022 (✓)

* Accepted in 2 Journal (SCI / SCIE):
-
-